Skip to main content

Posts

WEEK 14 (30/5 - 5/6)

 On week 14, I have purchased the TTGO ESP32 board and manage to complete the proposal to be submit. The board are expected to arrive on 15 June 2022 the earliest date. The other component are put on hold since it is always restock. 
Post a Comment
Read more
Recent posts

WEEK 13 (23/5 - 29/5)

 While fixing and completing my proposal, I was asked to start go through the coding and buy the components.  I manage to get the coding for my project from Ts. Dr. Izanoordina and senior. Most of the coding are general and must be altered to the project preferences. This is the example of coding from senior, where the microcontroller used is the same as me: The coding will be used as preferences only.
Post a Comment
Read more

WEEK 12 (16/5 - 22/5)

 In week 11, the presentation of FYP1 is done. The comment from the panels are taken into consideration, which is the problem statement do not comply with the limitation and methodology of this project.  Thus, Ts. Dr. Izanoordina ask me to meet her and discuss on that matter. In the mean time, I was asked to complete the proposal.
Post a Comment
Read more

WEEK 11 (9/5 - 15/5)

 In week 11, the budget are discussed based on the discussed hardware development used in previous task. Therefore, the budget in this task are: TOTAL COST FOR THE COMPONENT NO. COMPONENT COST (RM) 1 SOLAR PANEL 13.88 2 pH SENSOR 52.49 3 ULTRASONIC SENSOR 54.00 4 NPK SENSOR 335.35 5 TEMPERATURE SENSOR 4.50 6 EC SENSOR 165.89 7 TTGO ESP32 LORA 56.20 8 RELAY BOARD 16.00 TOTAL (RM) 698.31
Post a Comment
Read more

WEEK 10 (2/5 - 8/5)

 In week 10, the software used in this project are presented.  For coding, the Arduino.ide are used. FOr output display students discussed with Ts. Dr. Izanoordina the software that is compatible.  The proposed software are: Blynk ThingSpeak Both have GUI (Graphic User Interface) that is friendly with user. Next, the task will be on budget in this project.
Post a Comment
Read more

WEEK 9 (25/4 - 1/5)

 In hardware development, this project use: LM35 E-201C  RD NPK 01 RS485 LSE01 Ultrasonic Sensor TTGO ESP32 Soil Moisture Relay Where all the specifications of the hardware will be explained further in the proposal. The next task will be on software used in this project.
Post a Comment
Read more

WEEK 8 (18/4 - 24/4)

 On week 8, the block diagram, flow chart and circuit diagram are produced. Block diagram: From block diagram, Input: Ultrasonic Sensor NPK Sensor pH Sensor EC Sensor Temperature Sensor Ouput: ThingSpeak Board Relay Interface: TTGO ESP32 with coding from Arduino.ide software Flowchart: Circuit diagram: In next task list is hardware development of this project.
Post a Comment
Read more